250 litre Classic Slim Wall Water butt

Product Description

The Classic Slim 250l Rainwater Tank can be place directly on the floor, raised on a stand/plinth or wall mounted. 

The simple unique design makes it visually discreet and easy to install.

Multiple tanks can be joined together to achieve the desired storage capacity.

This tank can form part of an above ground pumped rainwater harvesting system by incorporating a pump to one of the tank outlets.

This tank incorporates two 4" access caps to allow backnuts to be fitted for diverters, overflows etc.

There are a number of draw off points to allow flexibility:

• 3 high level (approx 300mm from base)  3/4" BSP draw off points for the supplied high quality brass tap which can be used with a watering can.
  2 lower level (approx 150mm from base)  3/4" BSP draw off points for a pump drawoff.
  1 No. sump draw off at the base of the tank for tank cleaning

The drawoff points are NOT drilled allowing the customer to drill out the drawoff point to suit the requirement.

If a smaller slim wall mounted tank is required, consider the 100l Prestige wall mounted tank.

The Classic Ultra Slim 250l Rainwater Tank is manufactured in the UK.

Specification:

• Height: 1195mm
• Width : 995mm
• Depth: 250mm
• Capacity: 250 Litres
• Weight: 22kg
• Weight when full: 272kg
• Material: MDPE 

See the detailed Prestige Water colour specification here

Included Accessories:

• 5 x 3/4” BSP tank outlet fitting (undrilled, drill to suit with a 10mm drill bit) 
• 1 No. 3/4" brass tap
• 2 No 3/4" plugs
• 2 No. washers (wall fixings are not supplied and should be purchased to suit the substrate eg. solid brick, hollow brick, stone, timber, rendered block )

Optional Accessories

• Leaf catcher at the water butt inlet to capture leaves.
• Water butt sight level to see the water level in your tank at any time.
• Float & Dial Level Gauge to measure the capacity of water inside the tank
• Offset kit if a bend in the downpipe is required 
• Overflow Kit if a diverter/filter is not being used
• Filter collector universal diverter
• Tank Freshener to keep the tank fresh
• 250 Classic Water Butt Stand so the bottom outlets can be used to offer the full capacity
• Irrigatia solar water pump to water hanging baskets
• Wall bracket (widely available, would need to accept ~300kg load, not supplied from Freeflush)
• 2" BSP coupler
• Mains Back Up Kit
• External Pump System

Notes

The drawoff points are NOT drilled out, allowing the customer to select the drawoff point required. The chosen draw off point should be drilled through with a 10mm drill bit. 

This tank requires a fitting gap of 20mm between the tank and the wall to allow for expansion. The fixing points allow the tank to be secured to a wall or a stable fence.